Installing The Intrusion Switch Module - Dell EMC PowerEdge XR11 Manual Del Usuario

3. Lift the intrusion switch module out of the system.
Figure 29. Removing the intrusion switch module
Next steps
Replace the intrusion switch

Installing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE: The procedure to install the intrusion switch module is the same for Rear Accessed and Front Accessed
configurations.
NOTE: Ensure that you note the routing of all the cables as you remove them from the system board. Route the intrusion
switch cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
2. Using the Phillips 1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the power interposer board (PIB).
module.
Safety instructions.
Before working inside your system.
Instalación y extracción de componentes del sistema 41