Tarjeta De Boot Optimized Storage Subsystem S1 Opcional; Removing The Boss S1 Card - Dell EMC PowerEdge XR11 Manual Del Usuario

Figure 75. Installing expansion card in Riser 2 and 3
Next steps
1. Follow the procedure listed in
2. Install any device drivers required for the card as described in the documentation for the card.
NOTE: While replacing faulty storage controller or NIC or the GPU card with the same type of card, after you power on the
system, the new card automatically updates to the same firmware and configuration of the faulty one. For more information
about the Part replacement configuration, see the Lifecycle Controler User's Guide at
Tarjeta de Boot Optimized Storage Subsystem S1
opcional

Removing the BOSS S1 card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE: The procedure to remove the BOSS S1 card is the same for Rear Accessed and Front Accessed configurations.
Steps
Holding the blue tag, pull the BOSS S1 card away from the system board connector.
Después de trabajar en el interior del
Safety instructions.
Before working inside your
sistema.
system.
Instalación y extracción de componentes del sistema
https://www.dell.com/idracmanuals
81