Installing The Drive Into The Drive Carrier - Dell EMC PowerEdge XR11 Manual Del Usuario

Figure 35. Removing the drive from the drive carrier
Next steps
Replace the drive into the drive carrier.

Installing the drive into the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips 1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE: If the drive carrier has Torx screw , use Torx 6 (for 2.5-inch drive).
46 Instalación y extracción de componentes del sistema