Power Interposer Board; Removing Power Interposer Board (Pib) - Dell EMC PowerEdge XR11 Manual Del Usuario

información acerca de la configuración de reemplazo de piezas, consulte la Guía del usuario de Lifecycle Controller en
https://www.dell.com/idracmanuals

Power interposer board

This is a service technician replaceable part only.

Removing power interposer board (PIB)

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the PCI air shroud.
4. Remove both PSUs.
5. Disconnect all the cables that are connected to the system board, intrusion switch, Fan1, Fan 2 and Fan 3 from the power
interposer board (PIB).
NOTE: The procedure to remove the power interposer board (PIB) is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Using a Phillips 2 screwdriver, remove the screws securing the power interposer board to the system.
NOTE: Observe the routing of the cables as you remove them from the system.
2. Lift the PIB away from the system.
Figure 90. Removing the power interposer board
92 Instalación y extracción de componentes del sistema
Safety instructions.
Antes de trabajar en el interior de su equipo.