Control Panel; Removing The Status Led Control Panel For Rear Accessed Configuration - Dell EMC PowerEdge XR11 Manual Del Usuario

3. En la opción Seguridad del TPM, seleccione Encendida.
4. Guarde la configuración.
5. Reinicie el sistema.

Control panel

This is a service technician replaceable part only.
Removing the status LED control panel for Rear Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shrouds.
4. Remove the processor and heat sink
5. Remove the expansion card riser
NOTE: If necessary, please remove the backplane signal and power cables.
Steps
1. Using the Phillips 2 screwdriver, remove the screws that secure the left ear handle.
Figure 96. Removing the left ear handle for Rear Accessed configuration
2. Disconnect the status LED control panel cable from the system board connector.
NOTE: Observe the routing of the cable as you remove it from the system.
3. Using the Torx 8 screwdriver, remove the screws that secure the left control panel assembly to the system.
4. Hold the status LED control panel assembly and remove the control panel along with the cable from the system.
NOTE: Los números de la imagen no muestran los pasos exactos. Los números son solo para la representación de la
secuencia.
Safety instructions.
Before working inside your
module.
1.
system.
Instalación y extracción de componentes del sistema 99