SATA jet 1000 ROB RP/HVLP Manual De Instrucciones página 130

SATA ROB Automatic Gun Operating Instructions
EN
Notice!
The SATAminijet has no tapered dowel pin for aligning the air cap.
■ Screw the fluid tip [7-4] in using the SATA universal spanner.
■ Position the air cap ring [7-6] together with the air cap [7-5] and screw
on by hand. Heed the correct nozzle setting and check that the notches
in the air cap are aligned with the tapered dowel pin [8-1] (not in the
SATAminijet).
■ Insert the paint needle [7-3].
■ Position the spring [7-2].
■ Screw on the end cap [7-1].
■ Screw on the regulation cap (of variant with material flow control).
■ Adjust the material flow if necessary (see chapter 9.2).
10.2. Replacing the air distribution ring
Replacing the air distribution ring must be preceded and followed by the
steps required for replacing the nozzle set (see chapter 10.1).
Dismantle the air distribution ring
The air distribution ring is fitted firmly in the nozzle head, which can be
damaged if excessive force is used. Injuries can be caused if the SATA
extraction tool slips during use.
→ Wear protective gloves.
→ Always use the SATA extraction tool pointing away from your body.
→ Pull the air distribution ring evenly out of the nozzle head.
■ Carry out the steps to dismantle the nozzle set (see chapter 10.1).
■ Remove the air distribution ring [9-1] using the SATA extraction tool
[9-2].
■ Check sealing surfaces for damage and soiling, clean or replace if
necessary.
Fit new air distribution ring
■ Insert the air distribution ring [10-3] in the nozzle head [10-2]. The pin
130
Attention!