Fimar Sous Vide SV25 Uso Y Mantenimiento página 32

The machine can be put in pause while heating and during cooking by pressing the start button (N). Heating
resistance is turned off and the timer stops. To resume the program, press the start button
press the stop button (Q)
If the machine is paused for more than ten minutes it automatically goes into stand-by.
End of day cleaning
•
At the end of the day, unplug the power cable.
•
Clean thoroughly using neutral products.
•
Clean the external parts of the machine with a damp sponge.
•
Do not use steel wool or abrasive cleaning solutions.
Long machine downtime
If the machine is to be left inactive for an extended period of time, disengage the general wall switch, perform
general machine cleaning and cover it with a sheet to protect it from dust.
Error message
DISPLAY
H 2 O
E r r
s E r r
G E r r
Troubleshooting
In the event of faults or malfunctions, disconnect the main wall switch and contact your dealer's customer ser-
vice. Do not disassemble the internal parts of the machine.
The manufacturer declines all liability for any tampering!
FIMAR-RUSSIA.RU +7 495 989 1055
to terminate the program and place the machine in stand-by.
ERROR
The water level is too low. The machine pauses the cycle and
resumes automatically when water is added to the tank.
Core temperature probe not installed. Connect the temperature
probe and press
"START" or set the delta value to 0.
If th
Overheating error. Turn the machine off and on again
at the rear switch.
If the problem persists, contact technical support.
Gradient error. Turn the machine off and on again
at the rear switch.
If the problem persists, contact technical support.
CLEANING AND TROUBLE-
bl i t t t t h i l
17
SHOOTING
(N) again, or
t