Installation Steps - AVS Bugflector II Instrucciones De Instalación

Installation Steps

Center hood shield on hood and align with holes in hood. If the two outboard mounting locations are round holes,
If the two outboard mounting locations are oval slots, proceed to Step 4.
Outboard mounting
location
(round hole shown)
2
3
Press a bracket into each oval slot mounting location prior to installing hood shield.
4
Attach hood shield to hood using (2) fasteners at center mounting locations, and (2) screws
5
NOTE: Actual application may vary slightly from drawings.
proceed to Step 3.
Attach hood shield to hood using (4) fasteners. Proceed to Step 7.
If round holes here
If oval slots holes here
with washers at outboard mounting locations.
Page 2 of 3
Outboard mounting
location
(oval slot shown)
X4
Hood
Hood Shield
Fastener
Do not over tighten!
X2