Introduction; Installation And Operator Instructions - Saf-Fro DIGISTEEL 250C Manual De Instrucciones

Introduction

General Description
The welding machines
DIGISTEEL 250C
DIGISTEEL 250C PRO
DIGISTEEL 320C
DIGISTEEL 320C PRO
DIGISTEEL 380C PRO
DIGISTEEL 450C PRO
enables welding:

GMAW (MIG/MAG),

FCAW (Flux-Cored),

SMAW (MMA),

Installation and Operator Instructions

Read this entire section before installation or operation
of the machine.
Location and Environment
This machine will operate in harsh environments.
However, it is important that simple preventative
measures are followed to assure long life and reliable
operation.

Do not place or operate this machine on a surface with
an incline greater than 15° from horizontal.

Do not use this machine for pipe thawing.

This machine must be located where there is free
circulation of clean air without restrictions for air
movement to and from the air vents. Do not cover the
machine with paper, cloth or rags when switched on.

Dirt and dust that can be drawn into the machine
should be kept to a minimum.

This machine has a protection rating of IP23. Keep it
dry when possible and do not place it on wet ground
or in puddles.

Locate the machine away from radio controlled
machinery. Normal operation may adversely affect
the operation of nearby radio controlled machinery,
which may result in injury or equipment damage.
Read the section on electromagnetic compatibility in
this manual.

Do not operate in areas with an ambient temperature
greater than 40°C.
Duty cycle and Overheating
The duty cycle of a welding machine is the percentage of
time in a 10 minute cycle at which the welder can
operate the machine at rated welding current.
Example: 60% duty cycle
Welding for 6 minutes.
English
Break for 4 minutes.
The complete package contains:

Work lead – 3m,

Gas hose – 2m,

Driving roll V1.0/V1.2 for solid wire (mounted in the
wire feeder).
Recommended equipment, which can be bought by
user, was mentioned in the chapter "Accessories".
Excessive extension of the duty cycle will cause the
thermal protection circuit to activate.
Minutes
Input Supply Connection
Only a qualified electrician can connect the welding
machine to the supply network. Installation had to be
made in accordance with the appropriate National
Electrical Code and local regulations.
Check the input voltage, phase and frequency supplied
to this machine before turning it on. Verify the
connection of ground wires from the machine to the input
source. The welding machine DIGISTEEL 250C / PRO,
DIGISTEEL 320C / PRO, DIGISTEEL 380C PRO,
DIGISTEEL 450C PRO must be connected to a correctly
installed plug-in socket with an earth pin.
Input voltage is 400 Vac 50/60Hz. For more information
about input supply refer to the technical specification
section of this manual and to the rating plate of the
machine.
Make sure that the amount of mains power available
from the input supply is adequate for normal operation of
the machine. The necessary delayed fuse or circuit
breaker and cable sizes are indicated in the technical
specification section of this manual.
The welding machine can be supplied from a power
generator of output power at least 30% larger than input
power of the welding machine.
When powering the machine from a generator be sure to
turn off welder first, before generator is shut down, in
order to prevent damage to welder!
9
or decrease
Duty Cycle
WARNING
WARNING
WARNING
English