6 .6
Connecting control voltage cables
• Connect the motor's control voltage cable to the connection box.
• Mount the control panel at the helm position. There must be 90
mm of free space behind the panel.
• Connect the panel as shown in the dia-
gram.
See diagrams on page 214 if several pan-
els have to be connected.
See also diagrams on page 216 and 218
if you have installed both a retractable
bow and a retractable stern thruster.
• Connect the hub to a 12-Volt power sup-
ply.
n
ote
The hub should also be connected to 12
Volts in the case of a 24-Volt bow thruster .
n
ote
The CAN bus is a chain to which the bow
thruster and the panels are connected.
At one end of the chain, the power sup-
ply must be connected and the terminator
must be connected at the other end!
44
020584.01
Control panel
CAN-bus supply
24 V
+
12 V
Connection box thruster
MOTOR
To bow/stern
thruster motor,
pre-installed
Terminator
+
12 V
CAN-bus supply
- BPSRC
Terminator
Hub
Control voltage fuse
CAN
AUX IN
AUX OUT
Connection cable
+
12 V
CAN-bus supply
M
vetus® Installation instructions Retractable Thrusters
MOTOR
CAN
AUX IN AUX OUT
- BPJRC
Terminator
M