Cuppone Caravaggio Guia De Inicio Rapido página 38

Utilizzo
Use
D - Switching the light on (optional)
Fig.15.
When necessary, it is possible to switch on the oven
light to check the cooking, acting on the light key .
Press the same key to switch it off.
E - Adjusting the steam holes
Fig.16.
In the back of the cooking chamber there are some
steam holes: they can be more or less open to keep the degree
of humidity more suited to the type of product to bake in the
cooking chamber.
To open the holes, keep the button indicated in the figure pressed
continuously: they begin to open progressively. To block them in
the desired position, just release the key.
F - Activating an end-of-cooking signal (buzzer)
Fig.17.
If you wish, you can enable a buzzer that will go off
when the set time expires, warning that cooking is complete.
with the oven
To activate it,
after how long the acoustic signal will
The display will show
sound
(e.g. 3.3 that is three minutes and thirty seconds): if you
want to change this default time, use the "+" or "-" keys until the
display shows the desired time (e.g. 5.2 that is five minutes and
twenty seconds). After setting it, the countdown starts, at the
end of which a buzzer will sound to highlight the end of cooking.
To stop the buzzer, press the "clock" key.
the oven continues heating
Warning!
goes off!
G - Switching the oven off
Fig.18.
To switch the oven off, keep the ON/OFF key pressed
for about 2 seconds.
Programmed switch-on
The programmed switch-on function is very useful because
the oven can be already hot, and therefore ready to bake,
when the restaurant is opened.
with the oven
Fig.19.
To activate it,
the time to
The display will show
change this default time, use the "+" or "-" keys until the display
shows the desired time (maximum time 99.5 that is 99 hours and
50 minutes).
Once set, the countdown starts, at the end of which the oven will
switch on automatically with the temperature and power param-
for the last cooking.
eters used
If you wish to change them:
• exit programmed switch-on pressing the "clock" key,
• switch the oven on with the ON/OFF key,
• set a cooking cycle with the desired parameters
• switch the oven off with the ON/OFF key,
• set the programmed switch-on as explained above.
To exit the function and cancel programmed switch-on, touch
the "clock" key again.
Utilisation
Benutzung
on, press the "clock" key.
when the buzzer
off, press the "clock" key.
switch-on: if you wish to
Uso
Эксплуатация
TS MODELS
Knowing the control panel
Fig.20.
Pyrolysis program key: Starts the pyrolysis program to
1
clean the oven
ECO program key:
2 Starts the ECO program
explanation refer to the extended digital manual.
MAX program key:
3 Starts the MAX program
explanation refer to the extended digital manual.
TIMER key
4
Stand-by screen: enables the holiday mode;
Work screen: enables/disables the weekly switch-on timer
function.
Buzzer key: Activates an end-of-cooking acoustic signal
5
Program key:
6 Allows viewing and using the programs saved
by the user
Chimney key: Opens and closes the steam holes in the back
7
of the cooking chamber
Light key: switches the light in the cooking chamber on and
8
off
DIARY key: Gives access to the diary page
9
SERVICE key (settings): Gives access to the user's settings
10
for further explanation on use refer to the extended digital
manual.
ON/OFF switch: Powering the oven on and off
11
FUNCTION BAR
Current date
A
Chamber light
B
Shows the state of the light in the chamber (on or off )
Vent
C
If on, it shows the chimney is opening (the user is acting on
the chimney key 7 )
Warning
D
Highlights a warning to read (e.g. maintenance)
Current time
E
F PROGRAMMED SWITCH-ON key
Weekly programmed switch-on
Gives access to the
it is possible to program the oven automatically switching on
and off for the whole week
refer to the extended digital manual.
HOLIDAY key
G
Gives access to the
interrupting for a certain period of time the oven switching on
and off every week, without having to cancel it
explanation on use refer to the extended digital manual.
DIARY key
H
Diary
Gives access to the
to 10 notes that will be displayed at the set time on the set
day. Every note can also be repeated cyclically
explanation on use refer to the extended digital manual.
Use guided procedure
The oven can be switched on:
• manually: switching the oven on when it must be used it is
necessary to wait at least an hour for the oven to preheat and
get the right temperature
(points A, B, C, D, etc.)
programming it: setting the number of hours missing to the
•
next switch-on the oven will switch on automatically
ther explanation on use refer to the extended digital manual.
38
for further
for further
for further explanation on use
Holiday
page: this function allows
for further
page, where it is possible to set up
for further
Check the following use procedure
page:
for fur-