Install Cover Plate Assembly; Install Lower Cover - BIG ASS FANS Essence Guia De Instalacion

10. Install cover plate assembly

Plug the remaining male wiring harness from the fan into the female
wiring harness on the cover plate assembly as shown.
Ensure all wiring is tucked inside the extension tube, and then attach
the cover plate assembly to the extension tube using the Cover Plate
Assembly Hardware as shown.
Cover Plate Assembly Hardware (BAF-Supplied):
(2) 8-32 x 1/2" Flat Head Screw

11. Install lower cover

Remove the protective cover sheet from the bottom of the main fan unit before installing the lower cover.
Ensure that the three (3) stator wires on the bottom of the main fan unit are tucked in securely before installing the
lower cover. Be careful not to damage the stator wires while installing the lower cover.
WARNING: Disconnect power to the fan before installing the lower cover.
Attach the lower cover to the main fan unit using the Lower Cover Hardware as shown. Loosely attach all four (4) screws, and then
tighten them.
Lower Cover Hardware (BAF-Supplied):
(4) M4 x 8 mm Pan Head Screw
All manuals and user guides at all-guides.com
ESSENCE
Hanging the Fan (cont.)
WWW.BIGASSFANS.COM ©2013 DELTA T CORP.
®
ALL RIGHTS RESERVED
23
Cover Plate
Assembly