Front Wheel - APRILIA SR 50 Manual Del Usuario

1 3

FRONT WHEEL

DISASSEMBLY
Carefully read p. 44 (MAINTENANCE).
NOTE
Prepare a 210 mm high support, the
base of which must measure 200 x 200 mm.
◆ Place the support under the vehicle and a
spongy cloth between them, so that the
front wheel can move freely and the vehicle
cannot fall down.
WARNING
Make sure that the vehicle is stable.
use and maintenance SR 50
50
All manuals and user guides at all-guides.com
4
◆ Lock the wheel shaft (1) by means of an
hexagon spanner.
◆ Unscrew and remove the nut (2), taking
the washer.
Wheel shaft-nut driving torque:
50 Nm (5.0 kgm).
◆ Loosen the two screws (3) of the wheel
shaft clamp.
Driving torque of the wheel shaft clamp
screws: 12 Nm (1.2 kgm).
◆ Push the wheel shaft (1), by carefully
acting on the threaded end and using a
rubber hammer if necessary.
7
2
NOTE
Check the arrangement of the
speedometer drive (4) and of the spacer ring
(7), in order to be able to reassemble them
correctly.
◆ Support the front wheel and extract the
wheel shaft manually.
◆ Remove the wheel, carefully withdrawing
the disc from the brake caliper.
◆ Disconnect the speedometer drive (4).