Harbor Breeze TILGHMAN Manual Del Usuario página 9

DOWNROD-STYLE FAN MOUNTING
4.
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
Take the lead wires and make sure that you have
pulled them all the way through the top of the
downrod. Start at the TOP of the ball on the downrod
and measure 8 in. of lead wire, and then cut the
excess wire off with wire cutters (not included).
NOTE: If you do not cut back the lead wires, Steps 4
and 5 are not necessary and you may proceed to
Step 6 instead.
5. If you decided to cut back the lead wires in Step 4,
strip 1/2 in. of insulation from end of white wire.
Twist stripped ends of each strand of wire within the
insulation with pliers (not included). Repeat Step 5
for black, blue (if applicable) and green wires.
6. Install ball end of downrod (A) into mounting bracket
(C) opening. Align slot in ball with tab in mounting
bracket (C).
DANGER: Failure to align slot in ball with tab may
cause the fan to wobble or fall, which could result in
serious injury or death.
Continue to WIRING on page 11.
All manuals and user guides at all-guides.com
9
4
5
6
A
Lowes.com/harborbreeze
Ball
A
C
Tab
Slot