Sampler/Digital Scratch/Effector - Denon DN-2600F Instrucciones De Operación

9 SAMPLER/DIGITAL SCRATCH/EFFECTOR

DN-2600F's ASP (Audio Signal Processor) has three modes - sampler, digital scratch and effector - that can be selected freely according to the
purpose.
2 Sampler
• The sound of the disc can be recorded/played for approximately
15 seconds.
• The recorded sound can be looped in the normal or reverse
direction.
• The playing speed and level can be changed. In addition, the
key adjust function makes it possible to keep the key constant
even when the playing speed is changed.
2 Digital scratch
• The jog dial can be used to scratch with a feeling similar to
when scratching with an analog player.
2 Effector
• Three different effect functions can be used to create original
sounds. (In the effector mode, the playing level is 6dB lower
than the normal playing level.)
Selecting the ASP mode
1
Set the stop mode.
Set the ASP operation selection mode.
2
Press the MODE button.
Select the sampler, digital scratch or effector mode.
Turn the data master knob (
PUSH ENTER
3
Set the mode you want to operate.
Press the data master knob (
4
SAMP
or
Lit
— ).
8 9
Sampler?
D-Scratch?
Effector?
8 — 9 ).
DIGI-S EFFECT
or
(1) Sampler
Recording samples
1
Set the ASP to the sampler mode.
Start recording.
Press the PLAY/WRITE button.
ON/OFF ON/OFF
PLAY/WRITE PLAY/WRITE
2-
1
• The disc plays and the sound is recorded for
approximately 15 seconds. (The STOP LED lights when
recording is over.)
• Recording can be stopped before the 15 seconds is up by
pressing the STOP button.
[Sampling the seamless loop]
• When the end point (B) is set for the start point (A), the
standby mode is set at the start point (A) and recording is
started, recording stops at the end point (B). (During
recording, "Samp Load-B" is displayed on the character
2-
2
display.)
• If the section between points A and B is more than 15
seconds long, recording stops after 15 seconds.
For instructions on setting the standby mode at point A,
refer to "Fine-adjusting the start points" (page 16).
Playing the sampled sound
Press the PLAY/WRITE button.
• Playback of the sampled sound starts.
3
• The stop mode is set automatically once the end of the
recording is reached.
Stopping sampler playback
Press the STOP button.
4
• Sampler playback stops.
Clearing the recorded sample
Press the STOP button for at least 2 seconds.
• The recorded sample is cleared.
5
The sampler playback parameters and the LOOP and RVS
settings are reset to the default values.
ENGLISH
Lit
Samp Write
17