Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10 MEMO
Use this function to store the cue point, the pitch and the loop start point (A) and end point (B) in the memory and to call this data out.
Up to 300 sets of data, one set per track, can be stored in the memory.
The memory data can be copied between two RC-46s.
Storing data in the memory
Set the memo operation selection mode.
Set the player to the status you want to store in the
memory, then press the MEMO button.
1
Memo Set?
• If there are already 300 sets of data in the memory, "Memo
Full" is displayed and the data overwrite mode is set.
Store the data in the memory.
Press the data master knob (
Memo No.***
2
• The "
" indicator lights.
MEMO
• The memo mode is canceled after 1 second.
Overwriting data
If there are already 300 sets of data in the memory,
select "Over Write?".
3
Over Write?
Set the memory overwrite mode.
Press the data master knob (
4
Memo No.001
Select the data number you wish to overwrite.
Turn the data master knob (
5
Memo No.***
Display "Memo Set?".
Press the MEMO button.
6
Memo Set?
Store the new data in the memory.
Press the data master knob (
7
Memo No.***
MEMO DATA COPY
Two units of the DN-2600F are required (one master, one slave).
Connect the RC-46 remote control signal transfer connectors
(stereo mini jacks) with a cable as shown below.
(Tip)
Lch
1
RC-46
(Ring)
Rch
GND
(Sleeve)
—
).
8
9
—
).
8
9
—
).
8
9
—
).
8
9
(Tip)
Lch
RC-46
(Ring)
Rch
GND
(Sleeve)
Either open all the disc holders for the two sets or
2
remove all the discs.
Make presettings 14 and 15 and perform the memo
3
copy operation.
(Refer to page 26 for the presettings.)
Calling out data
Check that the "
MEMO
1
whose data you wish to call out.
Set the memo operation selection mode.
2
Press the MEMO button.
Select "Memo Call?".
Turn the data master knob (
3
Memo Call?
Set the memo data call mode.
Press the data master knob (
• When the cue point is stored in the memory, the cue
point is search for and the standby mode is set.
4
When the A point is stored in the memory, the data for
the A point is loaded.
• "Loading (memory number)" is displayed on the character
display while the data is being loaded, and "Complete!" is
displayed once loading is finished.
Clearing data
Set the standby mode at the track whose data you want
1
to clear.
Set the memo operation selection mode.
2
Press the MEMO button.
Select "Memo Clear?".
Turn the data master knob (
3
Memo Clear?
Set the data clear mode.
Press the data master knob (
Complete!
4
• The data is cleared and the "
off.
• All the data in the memory can be cleared at once using
the "Memory All Clear" preset function (page 26).
ENGLISH
" indicator is lit at the track
—
).
8
9
—
).
8
9
8
—
9
).
8
—
9
).
" indicator turns
MEMO
21
Publicidad
Capítulos
Tabla de contenido
