BABY born Zapf Creation Sister Manual Del Usuario página 15

• Batteries must only be replaced by an adult.
• Insert batteries with the correct polarity (+ and -).
• Do not mix different types of batteries or old and new batteries.
• The supply terminals are not to be short-circuited.
• Do not mix rechargeable and non-rechargeable batteries.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• When the product is not used for an extended time, switch button to "OFF" position for longer
battery life time. We also recommend removing batteries to prevent possible leakage and damage
to the unit.
• If moisture gets into the battery compartment, dry with a cloth.
• Exhausted batteries are to be removed from the toy and taken to special waste collection point.
• Do not throw batteries into a fire as they may explode or leak.
Preparation
Insertion of batteries should be done by an adult as follows:
ATTENTION! Before turning the shower upside down for a battery change, please ensure that all water
was removed from the shower.
1. Set the switch on the battery compartment to "OFF". (Fig. 7)
2. Use a screwdriver to open the battery compartment.
3. Insert the 4 x 1.5V AA (LR6) batteries. Please check if the polarity is correct.(Fig. 1)
4. Screw the cover of the battery compartment back on again. (Fig. 2)
Function
Please fill the tank to the mark with cold or lukewarm water by using an appropriate jar or similar (Fig. 3)
Afterwards, just place the tank on the tracks and carefully push it into the slot. (Fig. 3) The tank needs to
be pushed all the way to the end of the tracks to ensure a proper functioning. (Fig. 3B and 3C)
To place the doll under the shower, the shower head has to be extended to its complete length. To do
that, please open the door and push the button (Fig. 4 and 5). Move the shower head with the bracket to
the very top until it snaps in place.
Fix the doll in the doll holder and close the door. (Fig. 6)
To start the shower, please turn the knob either to the left or to the right. (Fig. 7 and 8)
ATTENTION! The temperature of the water does not change.
To stop the shower, please turn the knob back to the middle position. (Fig. 7)
After taking a shower, the doll can be released from the doll holder and should be dried thoroughly.
Cleaning
After playing with the BABY born® Rain Fun Shower, please empty the tank by carefully pulling it out of
the slot. (Fig. 9)
Return the empty tank in the slot of the shower base and start the shower function again by turning the
knob left or right. This will ensure that no water remained in the shower head. (Fig. 7)
Please remove the extra water by emptying the tank as explained before. (Fig. 9)
The BABY born® accessory can be cleaned with a damp (not wet) cloth. Please ensure that no
moisture enters the electronics or battery compartment.
Disposal according to WEEE (Waste Electrical and Electronic Equipment Directive)
All products marked with a crossed out wheeled bin cannot be disposed of in unsorted municipal waste.
Their collection must be done separately. Return and collection systems in Europe should be organized
by collection and recycling organizations. WEEE-products can be disposed of free of charge at the
appropriate collection points. The reason for this is to protect the environment and human health due to
the potential effects of the presence of hazardous substances in electrical and electronic equipment.
Beste ouders,
wij feliciteren u met uw aankoop van een product van Zapf Creation AG. Wij raden u aan om deze
NL
15