E N G L I S H
C. PADDED SWING-AWAY ARMRESTS (OPTIONAL)
Swing-away armrests can be detached or can swing away to allow lateral transfers. They are height
adjustable (1" increments) by moving bolt (A) up or down in predrilled holes on armrest bracket.
Additional height can be achieved by removing bolts (C), flipping and rotating the hardware to opposite
(D). Ensure bolts (C) are retighten.
Swing-away, removable armrests are installed by sliding armrest into receiver (B) on back frame.
1. Installation
Slide armrest into receiver tube on rear of frame.
2. Swinging Away
Lift armrest out of locked position and rotate to the side.
3. Removing Armrest
Pull armrest straight out of receiver.
D. HEIGHT-ADJUSTABLE ARMRESTS (OPTIONAL)
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will automatically lock into place.
2. Height Adjustment
a. Rotate height release lever (2) to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad (4) until upper armpost locks firmly into place.
3. Removing Armrest
a. Rotate height release lever (2) to first stop and remove the armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever (2) to locked position against armpost.
109881 Rev. B
5
6
6a
14
5
B
A
D
C
4
6
6
5
2
1
3
9
7
1. Outer armpost
2. Height Release
Lever
9
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Receiver
8. Clamp
9. Receiver adjustment
hardware
I X .
6a
7
8