Anti-Tip Tubes (Optional); Travel Wheels - Sunrise Medical Quickie 2 Manual De Instrucciones

E N G L I S H
Y. ANTI-TIP TUBES (optional)
Quickie recommends anti-tip tubes for all wheelchairs.
Use a torque setting of 115 in.-lbs. when setting up the anti-tip tubes.
1. Inserting Anti-Tip Tubes Into Receiver
a. Press the rear anti-tip release pin on the anti-tip tube so that both release pins are drawn inside.
b. Insert into the anti-tip tube receiver.
c. Turn the anti-tip tube down until release pin is positioned through the receiver mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Receiver
a. Remove anti-tip tubes from anti-tip receivers.
b. Remove bolts from anti-tip tube receiver.
c. Reposition bracket to desired height.
d. Reinsert bolts and tighten.
e. Repeat with second anti-tip tube receiver. Both brackets should be at exactly the same height.
f. Replace anti-tip tubes.
3. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be raised or lowered to achieve proper clearance 1 1/2" to 2".
a. Press the anti-tip wheel release pin so that the release pin is drawn inside.
b. Raise or lower to one of the three predrilled holes.
c. Release pin.
d. Adjust the second anti-tip tube wheel the same way. Both wheels should be at exactly the same
height.
4. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing curbs.
a. Press the rear anti-tip tube release pin.
b. Hold pin in and turn anti-tip tube up.
c. Release pin.
d. Repeat with second anti-tip tube.
Z. TRAVEL WHEELS
1. Removing Travel Wheel from Receiver
a. Remove quick-release pin (A).
b. Remove travel wheel from receiver.
c. Repeat for other side.
2. Inserting Travel Wheel into Receiver
a. Insert travel wheel into receiver.
b. Align holes at position for corresponding rear wheel size.
c. Insert quick-release pin (A) fully.
d. Repeat for other side. Both travel wheels should be at the same height.
3. Adjusting Travel Wheel for Axle Position
Travel wheel mounting configuration may need to be adjusted depending upon the axle sleeve location.
If mounting configuration needs to be adjusted to accommodate axle position:
a. Remove mounting screws (B) and travel wheel receiver (C).
b. Remove mounting bracket (D) from axle sleeve.
c. Rotate mounting bracket to correct orientation.
d. Secure mounting bracket to axle sleeve.
e. Secure travel wheel receiver to mounting bracket with mounting screws.
45
46
47
48
49
23
I X .
45
46
47
48
49
C
D
B
A
109881 Rev. B