3M Protecta Trigger 1200314 Manual Del Usuario página 8

5.0 INSPECTION
5.1 INSPECTION FREQUENCY: The Lanyard must be inspected at the intervals defined in Section 2. Inspection
procedures are described in the "Inspection & Maintenance Log" (Table 2).
;
Extreme working conditions (harsh environments, prolonged use, etc.) may require increasing the frequency of
inspections.
5.2 UNSAFE OR DEFECTIVE CONDITIONS: If inspection reveals an unsafe or defective condition, remove the
Lanyard from service immediately and destroy to prevent inadvertent use. Lanyards are not repairable.
5.3 PRODUCT LIFE: The functional life of 3M Lanyard is determined by work conditions and maintenance. Maximum
lifespan can range from 1 year for heavy use in extreme conditions to 10 years for light use in mild conditions. As
long as the product passes inspection criteria, it may remain in service up to a maximum of 10 years.
6.0 MAINTENANCE, SERVICE, AND STORAGE
;
Do not clean and disinfect the
methods may have adverse effects on the
6.1 CLEANING: Cleaning procedures for Lanyard are as follows:
• Periodically clean the exterior of the Lanyard using water and a mild soap solution. Water temperature must not
exceed 40 °C (104 °F). Position the Lanyard so excess water can drain out. Do not dry-clean. Do not iron. Clean
labels as required.
• Rinse and thoroughly air dry. Do not force dry with heat.
;
Use a bleach-free detergent when cleaning the Lanyards. Fabric softener or dryer sheets SHOULD NOT be
used when cleaning and drying the Lanyards
6.2 SERVICE: Lanyards are not repairable. If the Lanyard has been subjected to any damage or fall force, or inspection
reveals an unsafe or defective condition, remove the Lanyard from service and discard.
6.3 STORAGE/TRANSPORT: Store and transport Lanyards in a cool, dry, clean environment out of direct sunlight.
Avoid areas where chemical vapors may exist. Thoroughly inspect the Lanyard after any period of extended storage.
7.0 LABELS
Figure 8 illustrates labels on the the Lanyards. All labels must be present on the Lanyard - see Figure 1.
Information on each label is as follows:
Figure 8 Reference:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Lanyards
by any method other than described in the following "Cleaning Instructions". Other
Lanyards
Description:
Model number
Serial number
Batch number
Address of the Manufacturer
Read these instructions before use
European standard
CE Marking of European Conformity
Number of Notified body carrying out Conformity to type
Length
Month of manufacture
Year of manufacture
Web Address of the Manufacturer
Rope Diameter
Capacity
or user.
8