Mennekes AMTRON Serie Manual De Instrucciones página 65

DHCP client request delay
Static network configuration IP
Static network configuration netmask
Static network configuration gateway
Static network configuration DNS
Block 5: USB network
Parameter
Static USB network configuration additional IP
Static USB network configuration gateway
Static USB network configuration DNS
Block 6: Backend-System, network
Parameter
Public address of the
ChargePoint
Mode for selecting the public
address of the ChargePoint
WAN router password
SSL Strictness as client
SOAP OCPP Server Port of
ChargePoint (Standard OCPP)
SSL mode as server
Backend connection timeout
Display backend disconnect
as error
Block 7: Authorization, Backend-System
Parameter Description
OCPP mode Selection of the OCPP communica-
tion protocol
SOAP OCPP URL of URL address of the Backend-System
backend (standard
OCPP)
Backend Whitelist List of the IP addresses that are allo-
(SOAP) wed to send requests to the device
Description
Description
Public IP address of the ChargePoint
Mode for the selection type of the public IP
addresses of the charging point
Password for access to WAN router
SSL authentication as client
TCP server port for the incoming connections
from the Backend-System
SSL function and authentication as server
Time until an error message is displayed,
after the connection to the Backend-System
has been interrupted or could not be resto-
red
Setting that specifies, whether the error
"Backend disconnected" will be displayed.
Not relevant for the device
Not relevant for the device
Not relevant for the device
Not relevant for the device
Not relevant for the device
Necessary for ...
Not relevant for the device
Not relevant for the device
Not relevant for the device
Necessary
for ...
Backend-
System
Network
Backend-
System
Charging
system
Necessary Remark
for ...
Information will be provided by your
Backend-System provider
Backend-
„ Information will be provided by your
System
Backend-System provider
„ Only for "OCPP-S 1.5" and "OCPP-S 1.6"
Remark
Remark
Information will be pro-
vided by your Backend-
System provider
Only relevant, if "Display
backend disconnect as
error" = "On"
If this error is displayed
the "Fault" LED on the
device is flashing
23
EN