Spare Parts; Unlock The Charging Plug - Mennekes AMTRON Serie Manual De Instrucciones

Example:
... ...
Errors list Residual current
detected via sensor
... ...
Finding solution approaches for the error message
f Navigate to "Documentation" > "Errors Documentation".
In the second column, "Error activation message", all
error messages are listed.
f Find the current error message in the column,
Error activation message" and follow the solution
approaches in the column, "Corrective actions".
Example:
... Error ... ... Corrective actions
activation
message
... ... ... ... ...
... Residual ... ... The safety mechanism is reset to its
current original state every time the plug is
detected removed and automatically after 15
via sensor minutes if the plug is not removed. If
problem persists check yellow current
transformer and its connection.
... ... ... ... ...
Several Backend-Systems provide additional
assistance for troubleshooting.

9.2 Spare parts

If replacement or accessory parts are necessary for trou-
bleshooting, these must first be checked to ensure the
same design.
f Use only spare parts and accessories that are manuf-
actured and/or approved by MENNEKES.
Î "1.1 Service"
38
...
...
...

9.3 Unlock the charging plug

The tasks described below may only be carried
out by a qualified electrician.
If the unlock function fails, the situation can occur that the
charging plug is mechanically interlocked by the actuator.
The charging plug cannot be removed and must be unlo-
cked manually.
Fig. 21: Unlocking the charging plug
f Open the device.
Î "5.4 Opening the device"
f Fit the red lever (2) on the square shaft of the actuator
(1). The red lever is attached with a cable tie close to
the actuator.
f Turn the red lever on the actuator 90° clockwise.
f Unplug the charging plug
f Remove the red lever and fasten it close to the actua-
tor with a cable tie.
f Close the device.
Î "6.7 Closing the device"