Publicidad
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
RISK EXAMINATION
The points pointed by arrows
to prevent crushing, conveying, cutting, grappling, trapping so as to guarantee a safe installation for people, things
production.
SEA
can not be deemed responsible for any damage or accident caused by product breaking, being
damages or accidents due to a failure to comply with the instructions herein. The guarantee will be void and the
manufacturer responsibility will be nullified if
shall be carried out by a professional technician who will release documentation as requested by the laws in force.
Packaging materials such as plastic bags, foam polystyrene, nails etc must be kept out of children's reach as dangers
may arise.
INITIAL TEST AND STARTING OF THE AUTOMATION
After having completed the necessary operations for a correct installation of the Full Tank product, as
described in this manual, and after having valuated all resting risks which could arise in any installation, it is
necessary to test the automation to guaranty the maximum security and, in particular way, to guaranty
that the laws and norms of this sector are fully respected. Especially the test must be executed following
the norm EN 12445 which establishes the methods of tests for checking the gate automations respecting the
limits established by the rule EN 12453.
26
Cod. 67410845
®
To the attention of users and technicians
in fig. 26
are potentially dangerous. The installer must take a thorough risk examination
and animals.
(
Re. Laws in force in the country where installation has
been made.
As for misunderstandings that may arise refer to your
area distributor or call our help desk. These instructions
are part of the device and must be kept in a well known
place.The installer shall follow the provided intructions
thoroughly.
doors, gates and lwings. Any initiative taken without
explicit authorization
from whatsoever responsibility. The installer shall
provide warning notices on not assessable further risks.
SEA
in its relentless aim to improve the products, is
Fig.26
allowed to make whatsoever adjustment without giving
notice. This doesn't oblige
SEA
original spare parts are not being used.
REV 04 - 11/2010
)
SEA
products must only be used to automise
will preserve the manufacturer
SEA
The electrical installation
SAFETY GATE
For a correct and safe installation it is
strongly recommended to install a
Safety Gate, which allows the
fulfilment of the force diagram
included in the norm EN 12453 and
consequently the test and start of the
whole installation.
FULL TANK
English
English
SEA
to up-grade the past
Publicidad
