Publicidad
®
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
INSTALLATION OF THE OSCILLATING REAR BRACKET
(1)
Fig. 12
INSTALLATION OF REAR BRACKET
According to the type of opening that you have chosen
(inside or outside) and to the chosen leaf rotation (see
pag. 18-19), the rear bracket must first be cut respecting
the quote "a" on pag. 18-19 and then welded as in fig. 13.
The support must be positioned so that the operator is
perfectly levelled (Fig. 13, Fig. 15)
Adjustable rear bracket (with screws)
(Accessory on demand)
55 mm
Fig. 14
Cod. 67410845
Open carefully the package, making sure
not to loose parts which are listed in fig. 4
Attach the rear oscillating bracket as shown
in fig. 12
Attention: Do not use a hammer for the
insertion of the short brass pin; its fitting into
the bracket and clevis attachment must be
done by the simple pressure of the hands.
Fig. 11
Attention: Do not incline the hydraulic
operator further than the allowed angle of the
oscillating bracket (1), risks the possible
braking of it.
5
8 m
m
Fig. 13
REV 04 - 11/2010
FULL TANK
English
English
21
Publicidad
