Publicidad
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
INSTALLATION OF POSITIVE STOPS
Release the unit (as in fig. 24)
Make the shaft come out for ¾ of its stroke
Put the positive stops into the front flange of the unit with the two tie rods (of the three present on the stops)
which are parallel to the gate (Fig.19)
Fix the positive stops with the provided screws
Insert the ball joint after having installed the stops.
At this point couple the shaft to the front bracket
To adjust the positive stops in opening act on disk 1 and in closing act on disk 2.
Attention: The mounting of the mechanical positive stops does not cause the reduction of the shaft
stroke.
rods parallel to the gate
BREATHER SCREW
Cod. 67410845
®
Fig. 20
Unscrew and remove
the screw under the
operator at the end
Disc 1
ATTENTION
It is obligatory to remove the breather
screw at the end of the installation.
of installation
REV 04 - 11/2010
FULL TANK
English
English
Disc 2
Fig. 19
Fig. 21
23
Publicidad
