Honda CBX250 TWISTER Manual Del Propietário página 133

60
Rear Wheel Removal
1. Raise the wheel off the ground by placing a support
under the engine.
2. Remove the rear brake adjusting nut (1), disconnect
the brake rod (2) from the brake arm (3) by pushing
down on the rear brake pedal.
(4) (5)
(8)
(3)
(1)
3. Loosen the drive chain lock nuts (4) and drive chain
adjusting nuts (5).
4. Remove the rear axle nut (6), axle washer (7) and
chain adjusters (8), and pull out the rear axle shaft
(9). Push the wheel forward and remove the drive
chain from the rear sprocket.
5. Remove the rear wheel and side collar.
(5) (4)
(7)
(6) (8)
(1) Brake adjusting nut
(2) Brake rod
(3) Brake arm
(4) Drive chain
lock nuts
(5) Drive chain
(9)
adjusting nuts
(9) Rear axle shaft
(2)
(6) Rear axle nut
(7) Axle washer
(8) Chain adjusters
Installation notes
• To install the rear wheel, reverse the removal
procedure.
• Install the side collar into the left side wheel hub.
• Make sure that the lug (10) on the swingarm (11) is
located in the slot (12) in the brake panel (13).
• Tighten the rear axle nut to specified torque:
Rear axle nut torque:
88 N·m (9.0 kgf·m, 65 lbf·ft)
• Adjust the rear brake pedal freeplay (page 23) and
drive chain (page 55).
• After installing the wheel, apply the brake several
times and then check if the wheel rotates freely.
Recheck the wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
(12)
Owner´s Manual
(10) Lug
(13)
(11) Swingarm
(12) Slot
(13) Brake panel
(11)
(10)