Clutch - Honda CBX250 TWISTER Manual Del Propietário

24

Clutch

Clutch adjustment may be required if the motorcycle
stalls when shifting into gear or tends to creep; or if
the clutch slips, causing acceleration to lag behind
engine speed.
Minor adjustments can be made with the clutch cable
adjuster (4) at the clutch lever (1).
Normal clutch lever free play is:
10 – 20 mm (0.4 – 0.8 in)
(1)
1. Pull back the rubber dust cover (2).
2. Loosen the lock nut (3) and turn the clutch cable
adjuster (4). Tighten the lock nut and check the
adjustment.
3. If the adjuster is threaded out near its limit or if the
correct free play cannot be obtained, loosen the
lock nut and turn in the cable adjuster completely.
Tighten the lock nut and install the dust cover.
4. Loosen the lock nut (5) at the lower end of the cable.
Turn the adjusting nut (6) to obtain the specified free
play. Tighten the lock nut and check the adjustment.
(1) Clutch lever
(B)
(A)
(3)
5. Start the engine, pull in the clutch lever and shift into
gear. Make sure the engine does not stall and the
motorcycle does not creep. Gradually release the clutch
lever and open the throttle. The motorcycle should begin
to move smoothly and accelerate gradually.
(A)
(B)
(6) (5)
If proper adjustment cannot be obtained or the clutch
does not work correctly, see your Honda dealer.
Other Checks
Check the clutch cable for kinks or signs of wear that
could cause sticking or failure. Lubricate the clutch
cable with a commercially available cable lubricant to
prevent premature wear and corrosion.
Owner´s Manual
(2) Rubber dust cover
(2)
(3) Lock nut
(4) Clutch cable adjuster
(A) Increase free play
(B) Decrease free play
(4)
(5) Lock nut
(6) Adjusting nut
(A) Increase free play
(B) Decrease free play