Owner´s Manual
Bulb Replacement
(Refer to the Safety Precautions on page 43.)
The light bulb becomes very hot while the light is ON,
and remains hot for a while after it is turned OFF.
Be sure to let it cool down before servicing.
Do not put finger prints on the headlight bulb, as they
may create hot spots on the bulb and cause it to break.
Wear clean gloves while replacing the bulb.
If you touch the bulb with your bare hands, clean it with
a cloth moistened with alcohol to prevent its early failure.
• Be sure to turn the ignition switch OFF when
replacing the bulb.
• Do not use bulbs other than those specified.
• After installing a new bulb, check that the light
operates properly.
Headlight Bulb
1. Remove the screws (1) from the headlight case.
2. Gently pull the lower end of the headlight (2) forward
and remove the headlight.
3. Disconnect the connector (3).
4. Remove the seat rubber (4).
5. Remove the headlight bulb (5) while pressing down on
the pin (6).
6. Install a new bulb in the reverse order of removal.
(3)
(1)
(4)
(5)
(1) Screws
(2) Headlight
(3) Connector
(2)
(4) Seat rubber
(5) Headlight bulb
(6) Pin
(6)
65