Harbor Breeze WAVEPORT Manual Del Usuario página 14

FINAL INSTALLATION
4. To install the fan with the light kit, remove
preassembled hex nut (O) and lock washer (P) from
threaded rod at top of light kit fitter (F). Punch center
cap (N) out of switch housing (T) with a screwdriver
(not included). Gently feed molex wires (one at a
time) from light kit fitter (F) through hole in middle of
switch housing (T), and then screw switch housing
(T) onto threaded rod on light kit fitter (F) -- ensure
to align holes on pull chain guides with pull chains
on switch housing (T). Tighten hex nut (O) over lock
washer (P) for a secure fit.
5.
Connect WHITE molex wire from light kit fitter (F) to
WHITE molex wire from switch housing (T). Connect
BLACK molex wire from light kit fitter (F) to BLUE (or
BLACK) molex wire from switch housing (T). Make
sure molex wire connections snap together securely.
6.
Remove the three preassembled switch housing
screws (U) from preassembled switch housing plate
on motor housing (D). Connect male plug from motor
housing (D) to female plug from switch housing (T),
matching up the colors on the male plug with the
colors on the female plug for correct fit. Make sure
plugs are connected completely. Align holes in switch
housing (T) with holes in switch housing plate, and
secure switch housing (T) with three switch housing
screws (U) previously removed. Tighten all screws
securely.
All manuals and user guides at all-guides.com
14
4
Molex
Connections
O
P
Threaded
Rod
Pull Chain
Guide
F
Molex Wire
5
Connections
White
Molex
Wire
Pull Chain
Guide
6
Male
Switch
Plug
Housing
Plate
Female
Plug
U
T
F
Lowes.com/harborbreeze
T
N
Black
Molex
Wire
T
F
D
U