Settings; Record Menu - Blackmagic Design HyperDeck Shuttle HD Manual De Instalación Y Funcionamiento

Settings

The settings menu is arranged into 5 distinct categories, including record, monitor, audio,
storage and setup. Each of these submenus contain related settings, most of which can be
adjusted using the HyperDeck Shuttle HD control panel. Some settings are display only and will
appear greyed out, for instance, filename prefix. In this case, the setting can be adjusted via the
HyperDeck Setup utility.

Record Menu

Input
Displays the HyperDeck Shuttle HD HDMI input.
Codec
HyperDeck Shuttle HD can record compressed video using H.264, Apple ProRes and DNxHD
codecs. To use the teleprompter function, select 'teleprompter'.
Trigger Record
There are two trigger record modes available, including video start/stop and timecode run.
Some cameras, such as Blackmagic Pocket Cinema Camera 4K, send a signal over HDMI to
start and stop recording on external recorders. Selecting 'video start/stop' will trigger the
HyperDeck to start or stop recording when the record button is pressed on the camera.
Use the 'timecode' run option to trigger the unit to start recording when it receives a valid
timecode signal via the HDMI input. When the signal stops, recording will also stop. Disable
trigger recording by selecting the 'none' option.
NOTE When recording from an HDMI camera, make sure the output is clean with
overlays turned off as any overlays that are present in your camera's video output will
be recorded with your image.
Settings 12