Rear Panel - Blackmagic Design HyperDeck Shuttle HD Manual De Instalación Y Funcionamiento

Rear Panel

1 Power
HyperDeck Shuttle HD is powered via an AC plug pack. The supplied power cable
included features a locking connector to prevent disconnection, but you can also use
any 36W 12V power cable to power the HyperDeck Shuttle HD.
2 SD Card
Insert SD cards into the slot for recording and playback.
3 Ethernet
The Ethernet port lets you connect to your network for fast ftp transfers or to remotely
control the unit using the HyperDeck Ethernet Protocol. For more details on transferring
files via an FTP client, see the 'transferring files over a network' section later in
this manual.
When connected to the same network shared with an ATEM switcher, you can also
control your HyperDeck using the ATEM switcher or an ATEM hardware panel.
4 Ext Disk
Connect a flash disk to the USB-C connector so you can record to external disks at up
to 5Gb/s. You can also connect to multi port USB-C hubs or Blackmagic MultiDock 10G
to connect one or multiple SSDs.
5 HDMI
Connect the HDMI output to HDMI televisions, monitors or even a switcher, such as
ATEM Mini Extreme. The HDMI output is also used to view the menu overlay.
2
SD CARD
+ 12V DC
ETHERNET EXT DISK
1 3 4
HDMI OUT
HDMI IN
5
Rear Panel 21