Important - Medline MDS1001 Manual Del Usuario

How to Apply the Arm Cuff
1. Place the cuff directly on your bare upper arm.
2. Adjust the cuff so that the bottom edge lies
about 1 inch above the elbow on the inside of
the arm.
3. Align the Artery Mark (
artery, which runs down the inner arm. Position
the cuff hose straight down your arm, in line
with the middle finger.
4. Pull the end of the cuff and secure it snugly with
the hook and loop closures. You should be able
to fit two fingers between your arm and the cuff.
5. Confirm the indicator at the top, outer edge of
the cuff lies within the fit range (
6. Plug the air tube connector into the socket on
the left side of the monitor.
IMPORTANT: Make sure the cuff hose remains
straight along the arm and unkinked during
measurement.
Avoid compression and restriction of tubing.
16
) over the brachial
).
1 inch
Artery
Mark
Index and
Proper Fit Range
Air Tube
Connector
SYS
mmHg
Brachial Mark
DIA
mmHg
Palm
Facing Up