Descargar Imprimir esta página

Routine Maintenance - Dreame DreamBot W10 Manual

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 56
How to Use
EN
3. Place the robot onto the base
4. Start mopping
Press briefly the
button. The robot starts from the base and mops the house
based on the optimal cleaning plan scheduled by the map.
Note:
· If the robot is not on the base, please put it back before starting it.
· The robot will clean the mop pad before cleaning, please wait patiently until the
mop pad is cleaned.
· Do not manually move the base, fresh tank, waste tank, or washboard while mopping.
14
5. Return to self-clean
While mopping, the robot will return to the base to have the mop pad cleaned
as cleaning conditions set in the app. The robot resumes cleaning after the
mop pad is cleaned.
6. Clean the mop pad
After the robot completes cleaning and returns to charge, the base starts
cleaning and drying the mop pad.
Note:
· To clean the mop pad at any time, press and hold the
button on the base for 3
seconds to start cleaning.
· While cleaning the mop pad, if the water in the fresh tank is insufficient or the waste tank
is full, the robot will send a voice prompt, or the app will send a notification.
· After the robot completes mopping, clean the waste tank in time to avoid mold or odor.
It is recommended to change the mop pad every 1 to 3 months.
How to Use
Functions in APP
1. Map management
The homepage of the app displays the current map. On this page, No-Go
Zone allows you to set zones to be avoided, and Map Management allows
you to modify the current map .
2. Cleaning mode settings
Cleaning Mode on the homepage allows you to change the cleaning mode,
the suction power, as well as the humidity of the mop pad.
3. Self-cleaning settings
Self-Cleaning Settings on the homepage allows you to change the frequency
for self-cleaning and manually start a mop pad cleaning task or manually
start or end a mop pad drying task.
4. Product settings
The Settings page allows you to enable or disable device functions, configure
scheduled cleanup, or view cleaning history and device information.
Note:
· A map must be created before you use the room- or zone-based cleaning, and
manage maps.
· For more information about functions, check the corresponding interfaces or
guides in the app.
· The version of the app might have been updated, please follow the instructions
based on the current app version.

Routine Maintenance

Parts
For optimal performance, follow the instructions below to clean and maintain
the robot and base.
Part
Maintenance Frequency
Replacement Frequency
Dust Bin
Clean it as needed
/
Dust Bin Filter
Once every 2 weeks
Every 3 to 6 months
Fresh Tank
Once every 2 weeks
/
Fresh Tank Filter Media
Once every 2 weeks
/
Waste Tank
After each use
/
Washboard
Once every 2 weeks
/
Main Brush
Once every 2 weeks
Every 6 to 12 months
Side Brush
Once every 2 weeks
Every 3 to 6 months
Mop Pad
Once every month
Every 1 to 3 months
Universal Wheel
Once every month
/
Auxiliary Wheel
Once every month
/
LDS Laser Sensor
Once every month
/
Return-to-Base Sensor
Once every month
/
Cliff Sensors
Once every month
/
Signaling Area on Base
Once every month
/
Overflow Sensors on Base
Once every month
/
Charging Contacts on Robot
Once every month
/
Charging Contacts on Base
Once every month
/
Bottom of the Robot
Once every month
/
Body of the Base
Once every month
/
Note: The replacement frequency will depend on your usage of the robot. If an
exception occurs due to special circumstances, the parts should be replaced.
EN
15

Publicidad

loading