Preparations Before Use - Dreame DreamBot W10 Manual

Preparations Before Use

EN
1. Remove the protective strips
2. Install the side brush
Install the side brush
until it clicks into place.
Click
10
3. Place the base against the wall and charge the robot
· Install the base in as open a location as possible with a good Wi-Fi signal.
· Insert the power cord into the base and plug it into the socket.
· Place the robot onto the base, and the robot will trun on automatically and
start charging.
· It is recommended to fully charge the robot before the first use. After the
robot is fully charged, the status indicator illuminates white for 10 minutes
and then lights down.
Within the Best
Wi-Fi Range
> 1.5 m
Note:
· Remove any objects that are closer than 1.5 m from the front and 5 cm from either
side of the base.
· Make sure that no objects might block the signaling area.
· To prevent water stains from wetting wood floors or carpets, the self-wash base is
recommended to be placed on tile floors or marble floors.
Connecting with Mi Home/Xiaomi Home App
The appliance works with the Mi Home/Xiaomi Home app, which can be used to control the appliance and make it interact with other smart devices.
1. Download the Mi Home/Xiaomi Home App
Scan the QR code on the robot to download and install the Mi Home/Xiaomi
Home app.
Under the Cover
2. Add Device
Open the Mi Home/Xiaomi Home, tap " " in the upper right, and then
scan the QR code above again to add "Dreame Bot W10". Please follow the
prompts to finish the Wi-Fi connection.
xxxxxx' s home
Add a device
Scan
No home environment info
Devices Rooms
Note:
· Only 2.4 GHz Wi-Fi is supported.
· The app software is upgrading, and the actual operations may be different from
the statements in this manual. Please follow the instructions based on the current
app version.
3. Reset Wi-Fi
Simultaneously press and hold the and buttons until you hear a voice
prompt saying, "Waiting for the network configuration." Once the Wi-Fi
indicator is blinking slowly, the Wi-Fi has been reset.
Wi-Fi Indicator
· Blinking slowly: To be connected
· Blinking quickly: Connecting
· On: Connected
Note: If the robot cannot connect to your phone, Reset the Wi-Fi network and try
again.
EN
11