Reading Out Measured Values - De Dietrich INIDENS 24 Manual De Instalación Y Mantenimiento

9.4

Reading out measured values

F1 F2 F3 F4 F4
F3
BO-0000272-3
Tab.117 Read-only parameter list (not editable)
Setting Description
(read only)
AM001 DHW (Domestic Hot Water) mode enabled (0: Disabled, 1: Enabled)
AM010 Pump speed (0 ÷ 100%)
AM011 Service required (0: Disabled, 1: Enabled)
AM012 Status of appliance
AM014 Sub Status of appliance
AM015 Pump operation (0: Disabled, 1: Enabled)
AM016 Flow temperature
AM018 Return temperature
AM019 Actual water pressure in central heating system
AM024 Current output of the boiler
AM027 Outside temperature
AM036 Flue gas temperature
AM037 Status of the 3-way valve (0: Heating, 1: DHW)
AM040 Outgoing DHW temperature check
AM091 Season mode (0: winter, 3: summer)
AM101 Internal set point
BM000 DHW temperature
CM030 Current room temperature for zone
CM120 Current operating mode in the zone (0: Disabled, 1: Enabled)
CM190 Zone ambient set point
CM210 Outside temperature in the zone
CM280 Zone calculated set point
DM001 Temperature of the DHW tank
DM002 Outgoing DHW flow speed
DM005 Solar system DHW temperature
DM009 Primary operating mode (0: Programming, 1: Manual, 2: Antifreeze/Holiday)
DM019 DHW mode active (1: Comfort, 2: Low, 3: Holiday, 4: Antifreeze
DM029 DHW temperature set point
GM001 Actual fan RPM
GM002 Actual fan RPM setpoint
GM003 Flame detected (0: Not detected, 1: Detected)
GM004 Gas valve (0: Open, 1: Closed, 2: Off)
GM007 Start-up (0: Off, 1: On)
GM008 Actual flame current measured
GM012 Contact release signal X16 (0: No; 1: Yes)
7804841 - 02 - 20012022
To access the menu, press the two keys F3 - F4 together;
The symbol flashes on the display;
Press the F4 key to access the INFO menu;
Press the keys F2 - F3 to view the parameters;
Press the F1 key to exit
en
9 Settings
Value
0/1
%
0/1
List of statuses
List of sub-sta­
tuses
0/1
°C
°C
bar
0/100%
°C
°C
0/1
°C
0/3
°C
°C
°C
0/1
°C
°C
°C
°C
l/min
°C
0/1/2
1/2/3/4
°C
rpm
rpm
0/1
0/1/2
0/1
μA
0/1
INIDENS 193