Descargar Imprimir esta página

Kichler 56 Salvo Manual De Instrucciones página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
NOTE: Each handset control carries a unique ID code to facilitate communication between paired
devices. The ID code is set by factory and is not user changeable. However, you will be required to
perform an ID code learning process manually under these circumstances:
• If you have multiple fans installed within a close proximity and want to control all fans using a
same handset control.
NOTE: Each fan requires its own receiver.
• When your remote control is not responding (make sure battery is not dead).
• After you have replaced a faulty transmitter or receiver with a new one.
Otherwise the remote control will not work. To perform this process manually, follow steps below:
After installing and wiring the unit, restore power to your fan, press and hold the "LEARN" key
for 1-3 seconds, and the fan will turn on at medium speed and light (if installed) will turn on. This
confirms that the learning process has been completed. This operation must be completed within
30 seconds after restoring power to the fan. (Fig. 28)
NOTE: Ensure slide switch in battery compartment marked "D O" is set to "D" position. (Fig. 28)
Step 4. Replace the battery cover and tighten with screwdriver. (Fig. 28)
Step 5. The buttons control the fan speed and light as follows: (Fig. 29)
Low speed
Medium speed
High speed
Fan OFF
Airflow (Forward or Reverse)
No function (Do not use this button)
a.) Light ON/OFF.
b.) Press and hold to dim or brighten light to desired level.
18 | KICHLER.COM
Battery Cover
Battery Cover
Screw
Screw
Fig. 28
Fig. 29
Fig. 29
Fig. 30

Publicidad

loading

Este manual también es adecuado para:

330045