Configuration; Enabling The Dhcp Server; Configuration In Series Via Usb Stick - Keba KeContact M20 Manual De Configuración

M20
7

Configuration

This chapter describes the necessary configuration for the correct operation
of the charging stations. The following steps are required:
●
●
Depending on the network configuration, activation of the DHCP server on
the master may be necessary.
7.1

Enabling the DHCP server

To simplify the setup of a charging network, the master can be configured as
a DHCP server. This function is required for the network configuration when
the master and a client are connected directly or when a network connection
is implemented via switch.
The DHCP server on the master is deactivated in the delivery state and can
be activated using the configuration via USB stick or in the web interface.
7.2

Configuration in series via USB stick

There is the option of configuring multiple KC-M20 units with the same set-
tings. In this process, the configuration of a KC-M20 is saved on a USB stick
and then transferred to other KC-M20 units.
Preparation
For configuration using a USB stick, the following materials are required:
●
●
In addition, settings must be activated in the web interface (under Configura-
tion > Device) that permit the configuration to be read out and imported:
●
●
Necessary steps
The following steps are required to transfer the configuration from one KC-
M20 to another KC-M20:
●
●
Configuration manual V1.01
© KEBA 2022
Setting the DIP switch on the client charging station
Configuration (via web interface or using USB stick)
An empty USB stick, formatted with FAT32
Computer
"Allow USB init": Enables the readout of the configuration. This setting
must be activated on the charging station which provides the configura-
tion.
"Allow USB config": Enables the import of the configuration. This setting
must be activated in the charging station to which the configuration is
transferred.
Creating a configuration
Read out configuration
Configuration
275