Installing The Light Kit And Glass Shade - Kichler 52 Vinea Manual De Instrucciones

INSTALLING THE LIGHT KIT AND GLASS SHADE

CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The Electrical
Supply Circuit To The Fan Before Installing Light Kit.
Step 1. Hold the LED light kit to light plate, then connect the 2 single pin connectors
from the light kit to the 2 single pin connectors from the motor assembly. Connect
the black wire to the black wire, and white wire to the white wire. Attach the light
kit to the light plate and securely tighten with three (3) screws from the screw pack
(Fig. 22)
Step 2. Remove and retain the manual nut, metal washer and silicone washer from
the threaded rod on the light kit. (Fig. 23)
Step 3. Lift the glass shade up to the light kit, allowing the threaded rod to go
through the center hole in the bottom of the glass shade. Place the silicon washer
and metal washer over the threaded rod, then screw the manual nut onto the
threaded rod until tight. DO NOT OVER-TIGHTEN. (Fig. 23)
Step 4. Screw the finial to the threaded rod and securely tighten. (Fig. 23)
Light Kit
Fig. 22
Manual Nut
Finial
Fig. 23
Silicon Washer
Metal Washer
52" Vinea | 15