Battery - ARGENTO MiniMax Manual Del Usuario

The electrically power assisted cycle starts and powers its electrical and electronic functions following activation of the
lithium-ion battery supplied with the product. This is external and removable from the frame, recharged, installed and, if
applicable, activated by means of a key or dedicated switch.
Illustrative image of the battery structure and components
A. Battery activation switch (I= On / O= Off)* - *where supplied
B. Charging port for battery charger
C. Battery locking/release lock / Battery activation locking/release lock* - *where supplied
D. Residual battery charge indicator
Battery removal and insertion
The battery can be removed from the cycle to prevent theft, for charging or to be stored under optimal conditions.
Removing the battery:
Insert the key supplied in the lock on the battery. Turn the key counter-clockwise to the unlocking position. Remove the
battery from its slot on the frame stem tube sliding it upwards and outwards until it has been completely removed.
Inserting the battery:
Insert the key supplied in the lock on the battery. Turn the key counter-clockwise to the unlocking position. Insert the battery
in its slot on the frame stem tube and complete the installation by turning the key clockwise until it is locked.
Check that the battery is correctly installed and secured by trying to pull it out and/or making sure that it is securely fastened
to the frame and does not move.
Battery charging
Before using the electrically power assisted cycle for the first time, the battery must be fully charged using the battery charger
supplied.
The average time to fully charge the battery, which varies according to the residual charge level of the battery, can be
estimated as shown in the sheet below.
We recommend charging the battery with the specific battery charger after each use of the electrically power assisted
cycle.
CAUTION
Only use the battery charger provided or an approved model with the same technical specifications, taking care to observe
the same methods and precautions of use indicated on the charged or in the manual.
EPAC
MiniMax
MiniMax GT
MiniMad
Make sure that the electrically power assisted cycle is switched off and the battery is switched off/disabled (if required by the
model of battery supplied with the bike).
Make sure that the battery charger, its jack and the charging port of the battery are dry.

7. Battery

Battery charger INPUT
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
Battery charger OUTPUT
DC 42V 2.0A (Max)
DC 54.6V 2.0A (Max)
DC 42V 2.0A (Max)
20