Control Panel; Functions; Delay Start; Repeat Delay Period Every 24 Hours - Manitowoc SM Serie Manual De Instalación, Operación Y Mantenimiento

Operation

Control Panel

Delay
Power
Start
Automatic
Ice
Making

FUNCTIONS

Power Button (Green)
Pressing the "Power" button once will energize the ice
machine and green Power light. Pressing the "Power" button
a second time will de-energize the ice machine.
Automatic Ice Making Light (Blue)
This light is energized when the ice machine is the ice making
position. The light is off when the ice machine is in the clean
cycle.

Delay Start

Pressing the "Delay Start" button will initiate a delay cycle.
The ice machine will not run until the delay time expires.
• Pressing the button once will energize the 2 hour light
and initiate a two hour delay period.
• Pressing the button a second time will energize the 4
hour light and initiate a four hour delay period.
• Pressing the button a third time will energize the 8 hour
light and initiate an eight hour delay period.
• Pressing the button a fourth time will cancel the delay
cycle.
Clean (Green)
Pressing the "Clean" button will initiate a descaling/sanitizing
cycle and de-energize the "Automatic Ice Making" light. The
clean light will flash during the clean cycle to indicate the
proper time to add ice machine descaler or sanitizer.
Replace Filter (Red)
When the ice machine completes 8000 freeze/harvest
cycles the light will energize to indicate the filter needs
replacement. Depressing the "Clean" button for 6 seconds
will reset the counter and de-energize the light.
18
Replace
Water Filter
Clean
8
2 4
To reset:
Push and hold Clean button
Hours
for 6 seconds.
DELAY START
Pressing the "Delay Start" button will initiate a delay cycle.
The ice machine will not run until the delay time expires.
• Pressing the button once will energize the 2 hour light
and initiate a two hour delay period.
• Pressing the button a second time will energize the 4
hour light and initiate a four hour delay period.
• Pressing the button a third time will energize the 8 hour
light and initiate an eight hour delay period.
• Pressing the button a fourth time will cancel the delay
cycle.

REPEAT DELAY PERIOD EVERY 24 HOURS

1. Press power button to stop the ice machine.
2. Press the delay button - The power LED will energize
and the 2 hour delay LED will blink 3 seconds on and 1/2
second off to indicate a 2 hour delay is in effect every 24
hours.
3. Pressing the delay button again will energize the 4 hour
light and initiate a four hour delay period every 24 hours.
4. Pressing the delay button again will energize the 8 hour
light and initiate an eight hour delay period every 24
hours.
5. Pressing the delay button again will cancel the 24 hour
repeat delay. Start with step 1 to reenter 24 hour delay
setup.
EXAMPLE
Setting a daily 4 hour delay from 1 pm to 5 pm.
At 1 pm perform steps 1 through 3 above. The 4 hour delay
light will blink every 3 seconds to indicate it is in a delay
period. After 5 pm the ice machine will fill the bin as needed.
At 1 pm on all following days the ice machine will initiate a
delay period at 1 pm and flash the 4 hour delay LED.
Canceling a 24 hour delay period
• Press the power button while a delay period is active.
• Follow "Repeat Delay Period every 24 Hours" to step 5.
• Disconnect/reconnect the main power supply.
Part Number 000001590 Rev05 07/22
Section 3