Bondioli & Pavesi SFT PRO Serie Manual De Instrucciones página 18

ENG
AUTOMATIC BALL COLLAR
14
Pull the collar back until it locks in the open position. Push or pull the yoke
along the shaft until the balls engage the groove and the collar returns to its original
(closed) position. Make sure the collar returns to its initial (closed) position and the
yoke is properly attached to the shaft.
LUBRICATION
Always wear adequate safety equipment when performing any maintenance
15
or repair work.
Do not modify or tamper with any part of the driveline. For any operations
16
not explained in this instruction manual, consult your local Bondioli & Pavesi
representative.
Check the efficiency of each component and lubricate before using the
17
transmission. Clean and re-lubricate the driveline before seasonal storage.
Lubricate the components according to the layout shown on the label, the
lubrication intervals are expressed in hours.
The quantities of grease indicated on the label are recommended for the specified
interval of hours. Particularly severe applications in aggressive environments
may require more frequent lubrication.
Quantities specified in grams (g). 1 ounce (oz.) = 28.3 g (grams).
Inject grease into the cross kit until it purges from each bearing cap.
Pump progressively and avoid high pressures from the grease gun.
Recommended grease NLGI 2.
Following seasonal use, it is recommended to clean out any grease inside the CV
shield.
CV-JOINT - The quantity of grease indicated on the lubrication label of the
driveline is indicative. For correct lubrication it is recommended to pump grease
via the grease fitting every 250 hours until the grease begins to escape from the
filling valve.
TORQUE LIMITER AND OVERRUNNING CLUTCH
OVERRUNNING CLUTCH
18
This device prevents transmission of inertial loads from implement to the
tractor during deceleration or stopping of the PTO.
The overrunning clutches do not require lubrication and are not equipped with
grease fittings.
Keep clear of the machine until all parts have stopped moving.
LB - SHEAR BOLT TORQUE LIMITER
19
This device interrupts the transmission of power by shearing a bolt when the
torque exceeds the setting.
Replace the sheared bolt with the same diameter, length and grade as the original.
Lubricate the LB limiters with grease fittings at least once every season and after
long periods of storage.
LR - AUTOMATIC TORQUE LIMITER
20
This device interrupts the transmission of power when the torque exceeds
the setting. To automatically re-engage the device, slow down or stop the PTO.
This device is sealed - no additional lubrication is required.
18