Depth Adjustable Backrest; G.TEnsion Adjustable Seat Sling Adjustment; H.BAckrest Tension Adjustable - Sunrise Medical Zippie ZONE Manual De Instrucciones

E N G L I S H
F. DEPTH ADJUSTABLE BACKREST
The backrest may be adjusted for depth change by loosening the two bolts on each side of
the axle backrest bracket (4 bolts total) (A) and sliding the assembly. Once each side (RH &
LH) are positioned and aligned with each other, tighten bolts (A) to specified torque.
G. TENSION ADJUSTABLE SEAT SLING ADJUSTMENT
The tension adjustable seat sling (C) can be adjusted for depth change by loosening the front
Velcro strap (B) and unfolding to the desired depth. Once the sling length is set, replace and
re-tension the front tension adjustable sling (B).
To increase depth, unfold Velcro flap (B) to add one or two additional inches.
Straps on frame (D & E) should be tightened before replacing sling (C).
H. BACKREST TENSION ADJUSTABLE
To install the Backrest Tension Adjustable
1. Slide Velcro straps (F) over the backrest frame section. Make sure to include at least
one strap below the towel bar (if using a rigid chair).
2. Tighten the straps appropriately to desired tension level. DO NOT overtighten straps
as this will cause undue strain upon the chair backrest frame (G).
3. If using fold down push handles, insert the single Velcro strap (H) through the slots in
the front of the push handles ( I ).
If using inegral push handles ( J ), slide straps from bottom of backrest upward.
4. Install backrest cover at desired level and fold over rear of Velcro strapping system (K).
The Zippie patch should be upright on the rear of the chair.
5. Finish installation by placing vanity flap (center panel) down onto Velcro on the seat
sling to secure attachment (L).
Adjusting the Backrest Tension Adjustable
Suggest using anti tips while making any adjustments. Ensure anti tips are safely secured and
in a position to prevent the wheelchair from tipping backwards.
1. User can transfer into wheelchair. Place wheel locks in the locked position
2. From the rear of the wheelchair the attendant can lift the Vanity Flap (Center panel) to
access the strap system. Adjust straps for optimal balance and truck alignment. Ensure
the Velcro straps has a minimum of 2"s of engagement, hook securing to loop. Press
the Velcro together to ensure it's securely engaged.
3. Once adjustments have been finalized replaced Vanity Flap to its original position.
Any changes made to the straps will affect the center of gravity. Suggest the
user has the attendant stationed behind the wheelchair to prevent the wheel-
chair from tipping backwards while they become accustomed to the adjustment.
116100 Rev. B
All manuals and user guides at all-guides.com
10
12 13
WARNING
16
11
E
14 15
L
10
A
11
C
B
D
12
F
G
13
H
I
14
J
K
15
I X .