Check-Out; Troubleshooting - Sunrise Medical Zippie ZONE Manual De Instrucciones

E N G L I S H
T. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces-
sories should also perform smoothly. If you have any problems, follow these procedures:
a. Review assembly and adjustment sections to make sure chair was properly prepared.
b. Review trouble shooting guide.
c. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
You will need to adjust your chair from time to time for best performance (especially if you
alter the original settings). This chart gives you a first solution, then a second and a third if
needed. You may need to look farther to find the best solution for a specific problem.
NOTE– To keep track of your progress, make only ONE change at a time.
   
  
 

  

116100 Rev. B
All manuals and user guides at all-guides.com
X. TROUBLESHOOTING
SOLUTIONS
Make sure tire pressure is correct and equal in
both rear tires and front caster tires, if pneumatic.
 
Make sure all nuts and bolts are snug.
Make sure all spokes and nipples are tight
on radial spoke wheels.
Use Tri-Flow Lubricant (Teflon®-based)
between all modular frame connections and
parts.

Check for proper caster housing adjustment.
See instructions for caster adjustment.
Check for proper toe-in/out adjustment.
See instructions for proper adjustment.
22
X . T RO U B L E S H O OT I N G
I X .