Lower Anchor Installation - Britax ADVOCATE Guia Del Usuario

Britax Child Safety, Inc.

Lower Anchor Installation

IMPORTANT:
for a child weighing more than:
‐ ADVOCATE ONLY: 35 lbs (15.8 kg)
‐ BOULEVARD ONLY: 40 lbs (18 kg)
1. Remove the lower
connectors from the
storage compartment at
the rear of the seat and
pull the strap to full length
toward the child's left
side.
2. Remove the tether
from the tether storage
compartment and retainer
tabs and place it up and
over the child seat back.
3. Place forward-facing on
the vehicle seat.
NOTE: Ensure that the
base of the child seat is
flat on the vehicle seat
and no more than 3 in.
(7.5 cm) of the base
hangs over the edge
of the vehicle seat (see
page 27).
4. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
5. Slide the lower connector
strap into the forward-
facing belt slots and
firmly press the lower
connectors over their
adjacent lower anchors.
NOTE: Verify that the
connectors are secure
and the strap is not
twisted.
6. Pull the end of the lower
connector strap to
remove slack.
16
Do not install forward facing with lower anchors
Table of Contents
3"
4a
4b