Uninstalling The Seat - Britax ADVOCATE Guia Del Usuario

Overhang
It is important that the
base of the child seat
rests completely flat on
the vehicle seat with no
side overhang. As seen
in the illustration, it is
permissible to allow up to
3 in. (7.5 cm) of the base
to hang over the front
edge of the vehicle seat.
If the vehicle seat does
not allow enough of the
child seat base to make contact, adjust the recline angle to
a more upright position. Not doing so could cause the child
seat to not perform as intended.
IMPORTANT:
MUST be parallel to vehicle seat.
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised
high enough to properly adjust the
harness for the fit of your child when
using a forward-facing reclined
position. DO NOT force the child
seat head restraint past the vehicle
head restraint. Doing so could cause the child seat not to
perform as intended. If the location of the vehicle head
restraint interferes with the child seat head restraint,
raise, or remove the vehicle head restraint. If the vehicle
head restraint cannot be removed, move the child seat to
the upright position or try a different seating location.

Uninstalling the Seat

1. Unbuckle the vehicle seat
belt.
NOTE: For car seats
installed with lower
connectors, see pages
29-30.
2. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
Car seat base MUST be flat on vehicle seat and
WARNING!
3"
Acceptable
Forward-Facing
Table of Contents
3"
Acceptable
Rear-Facing
2a
2b
27