GASPARDO VITIGREEN Empleo Y Mantenimiento página 28

ENGLISH
3.0 RULES OF USE
To obtain the best performance from the equipment, carefully
follow what is set out below.
ATTENTION
The following maintenance, adjustment, and work preparation
operations must be performed with the tractor off and locked
firmly in position with the key removed from the dashboard
and the seeder positioned on the ground.
3.1 ATTACHMENT TO THE EQUIPMENT
3.1.1 ATTACHING THE TRIANGULAR QUICK CONNECTOR
The triangle for quick connecting and disconnecting the seeder
and the equipment to which it is coupled can be supplied with
the seeder (COMBINE). The triangle is fitted permanently to the
equipment (Fig. 7).
3.1.2 FITTING THE TRANSMISSION TO THE REAR
ROLLER OF THE ROTATING HARROW
Before coupling the seeding unit to the equipment, the supplied
transmission must be fitted to the rear roller, in order to obtain
the power required to distribute the seeds.
1) Remove the lubricator (1 Fig. 8) and flanged bearing (2),
mounted on the left hand side of the roller, removing the four
fixing screws.
2) Modify the left roller support, following the instructions shown
in Figure 9:
a = Ø 8,5 mm;
b = Ø 21 mm;
c = Ø 18 mm.
3) Assemble the parts (3) and (4) (Fig. 8) on the side of the roller,
using the four fixing screws.
4) Screw the axis (5) onto the flanged bearing (3).
5) Mount the gear on the axis (6) (Z11 o Z17), locking into position
with the plug provided.
6) Mount the transmission chain (7), tightening using the chain
tensioner provided (8).
7) Protect the transmission unit with the guard provided (9).
3.1.3 HITCHING THE PLANTING UNIT TO THE EQUIPMENT
Hitching the planting unit to the equipment is a very dangerous
operation. Be very careful in following the instructions for the
whole operation.
It should be carried out on a firm, horizontal surface with the
planting unit placed on its support props.
1) Hook up the equipment (rotating harrow) to the tractor following
the manufacturer's instructions (see Instruction Manual).
2) Grease the guides (A Fig. 10) of the triangle to facilitate the
hooking up.
3) Bring the tractor to the seeder; using the lift, move the quick
connect triangle until it is vertically above the coupling triangle
of the seeder (Fig. 10).
ATTENZIONE
Durante la fase di aggancio tra la seminatrice e l'attrezzatura
è vietato stazionare nella zona intermedia alle due.
28
DANGER
USE AND MAINTENANCE
fig. 7
9
fig. 10
A
g
7
8
5
1
4
6
(a)
46 mm
(c)
(b)
3
2
fig. 8
fig. 9
B
cod. G19502451