Diono Radian 3R Manual Del Usuario página 14

FIRST SETUP
UNFOLDING AND FOLDING
1. Place car seat on its back on a flat surface and
unfasten red carry strap from the bottom. Be sure
the harness adjuster moves freely and is not locked
within the bottom of the seat.
2. Rotate bottom until your hear it
"click", this confirms the car seat
is locked for use.
3. Check proper operation — Pull
harness adjusting strap until
harness begins to tighten. If it
does not tighten freely, check the belt path on the
back of the seat bottom is clear from obstruction. To
fold seat, release the levers as shown and repeat the
above steps in reverse.
4. Tuck the red strap through the harness slot and store
behind the cover.
5. To fold, push lever shown and secure with red strap.
26
Radian® 3R
1.
CLICK!
2. Place harness straps over child's shoulders and
folding/
release
lever
3. Be sure the harness straps are at the proper height.
US & CA EN
HARNESS SETUP
Place your child in the seat. Make sure their back is
flat against the car seat back (this can be done in or
out of the car). Avoid bulky or heavy clothing because
they will prevent the harness straps from being
tightened properly at first fitment.
legs and buckle. You will hear a "click" when buckle
tongues are securely attached. Pull up on each
buckle tongue to make sure it is securely attached.
Rear-facing: Harness straps MUST be at or just
below the child's shoulders. Top of head must be 1.5 in.
(3.8 cm) below the top of the car seat shell.
REAR-FACING
Harness AT or just below shoulders
diono.com
FIRST SETUP
27