Diono Radian 3R Manual Del Usuario página 18

5. Place car seat rear-facing in
back seat of the vehicle. Center
the car seat between the vehicle
LATCH anchors. The entire seat
bottom should sit flat on the
vehicle seat.
6. Slide the LATCH strap through
the rear-facing belt path and
out the other side. The LATCH
strap should lie flat and not be
twisted.
7. Attach LATCH connectors to
vehicle LATCH anchors and
listen for audible "click" to
confirm engagement.
34
Radian® 3R
8. Tighten the LATCH strap. Press
5
5
9. Test for tightness. Grab the
6
6
10. To remove LATCH strap from
7
7
down firmly in the center of the
car seat while tightening the
LATCH strap. You may need
to tighten further by pulling
upwards in-line with the belt
path as shown.
side of the seat with one hand
where the LATCH strap is and
slide the car seat side-to-side
and front-to-back. If the seat
moves less than 1 in. (2.5 cm), it
is tight enough. Do not test by
grasping the top or back of the
car seat.
vehicle — Use LATCH release
on the LATCH connectors and
pull them off the anchor bars.
diono.com
8
8
9
9
10
10
35