Diono Radian 3R Manual Del Usuario página 26

6. Tighten the top tether strap.
Push the car seat back while
tightening the tether strap to
remove all the slack.
6 6
7. Test for tightness. Grab the side
of the car seat with one hand
where the seat belt strap is and
slide the seat side-to-side and
front-to-back. If the seat moves
less than 1 in. (2.5 cm), it is tight
7 7
enough. Do not test by grasping
the top or front of the car seat.
50
Radian® 3R
LAP BELT CUSHION
For forward-facing installations using a
ONLY with NO top tether available from 22–65 lb
(10–29.5 kg). DO NOT USE REAR-FACING.
1. Remove the center buckle pad by
pulling it carefully up and over the
buckle.
2. Unclip seat cover from seat
bottom. Lift seat cover away from
the seat bottom and remove the
buckle.
3. Place lap belt cushion on seat
bottom, and slide the buckle
through the slot in the cushion
that matches the slot position
being used on the seat.
4. Guide buckle through seat cover
bottom and memory foam cushion.
Reattach cover to seat bottom.
5. Reinstall the center buckle pad.
Should you need a longer buckle, these are
available by calling Customer Care.
diono.com
LAP BELT
1 1
2 2
3 3
51