Diono Radian 3R Manual Del Usuario página 24

7. Attach LATCH connectors to
vehicle's LATCH anchors and
listen for audible "click" to
confirm engagement. LATCH
strap should lie flat and not be
twisted.
8 7
8. Tighten the LATCH strap.
Press down firmly in the center of
the car seat while tightening the
LATCH strap. You may need to
tighten through the opening in the
9 8 8
cover by the belt path shown, by
pulling it through and up. pulling it through and up.
9. Test for tightness. Grab the side
of the car seat with one hand
where the LATCH strap is and
slide the seat side-to-side and
front-to-back. If the seat moves
10 9 9
less than 1 in. (2.5 cm), it is tight
enough. Do not test by grasping
the top or front of the car seat.
46
Radian® 3R
10. Tighten the top tether strap.
Push the car seat back while
tightening the tether strap to
remove all the slack.
11. To remove LATCH strap from
vehicle, use LATCH release on
the LATCH connectors and pull
them off the anchor bars.
own, by
12. To loosen or remove the top
tether, push in on the grey
button to loosen, then unclip the
top tether.
11 10
12 11 11
12
12
diono.com
47